Logout and Login after discovery to continue to use show commands. only little show commands are available with this mode (this is mentioned below.) ![]() Today we Power ON the switch and access the console, after the boot process switch went in to "(none) login:" mode & asking username and password (we don't know default password), so we tried several password out of this username 'admin' accepted without password & switch went in to " (none)# " mode. Could you please share NX-OS commands study material. If the access point cannot detect any DHCP, it will use its default IP, which is 192.168.1.1. If connected to a DHCP Server, it will get a DHCP address. ![]() If it cannot detect a DHCP after 60 seconds, it will change to its fixed IP which is 192.168.1.200. Unfortunately we are very beginner with Nexus family switch ( NX-OS configuration commands). Find the IP address from the routers DHCP Clients Table. Kindly guide us to complete our core switch change over with Nexus.Īny reference or guidance is very much 56853 6364 So to increase network performance now we are planning to replace existing core switch with Nexus N9K-C9372TX, unfortunately we are not familiar with these Data Center switch. Edge switch is connected with both Core switches and make 1st Core Switch as Root Bridge and 2nd as BDR. Trunk Link (EtherChannel) b/w Two Core Switches for HA.Ġ4. each host is connected to both switch (this is on Vlan 6) and HSRP is configured for VLAN 6 b/w two core switches.Ġ3. NAS having two controller, First Controller is connected to First Core Switch & Second Controller is connected to Second Core Switch Respectively (and this is VLAN 12 & each both switch vlan having ip. Network Attached Storage (Net App) Configuration. ![]() We are planning to Replace our Core Switch (C3750- 2 Nos, configured with HSRP) with Nexus N9K-C9372TX (2 Nos.).Įxisting core switch (C3750) configurations are mentioned below.Ġ1.
0 Comments
Leave a Reply. |